PEGBOARD CONNECTION ACCESSORIES FOR N POLDER 4P SET WH YP01

Don't forget this is necessary for attaching the punching board!

It's a necessary part for fixing the perforated board, but it's sufficient for assembling it on its own. If you put it in from the bottom to fix it on the back, it will fall unless you hold it down at first, so it would be better if you could put it in from the top. For me, I'm not assembling it on its own, but connecting it to make an N-Polda, so it would be nice if this part could be used to fix the perforated board on both sides. (Like a butterfly shape? So that it can be attached to both sides) It would reduce the amount of parts, make the location of the fasteners neater, and reduce costs. I know there are various things to consider, such as load capacity and the break-even point, but I would like you to consider this product, as Nitori is more than just a low-priced store.

I tried to assemble it according to the instructions that came with the perforated board, but when I tried to put the shelf back in place at the final stage 9, the shelf wouldn't fit properly, probably because the whole N-Pordar was distorted when I attached the perforated board. I went back to step 6 and attached the shelves to the top and bottom shelves first, and then attached the board after fixing the distortion of the entire N-Polda. As this part is attached to the perforated board from behind with screws, you have to remove all the N-Polda tension rods and shelves, detach them from the wall, assemble them, and then reattach them to the wall. If you buy N-Polda and then think “I'd like to attach the perforated board, but I can add it later...” and then attach it later, you'll end up having to do it twice. It would have been much easier if I'd bought the punching board and connecting parts when I first assembled the N-Polda, and installed them all at once.